Roll lettering until you are ready to apply it. Do not bend or fold.
	For best results, pre-measure the location for your lettering, using a level and ruler. Mark position with a pencil. Make sure surface where lettering will be applied is clean, dry and smooth.
	Rub over the lettering with a credit card or plastic spatula.
	Peel white backing paper away from the lettering and sticky transfer tape at an angle.
	LIGHTLY position sticky ends of tape with lettering on the desired surface (wall, mirror, tile, board, etc). Gently adjust the position of the lettering if needed.
	Gently rub over lettering with a credit card or plastic spatula to transfer to desired surface.
	Slowly peel off the transfer tape at an angle, re-rub any lettering that sticks to the tape and re-apply pressure to lettering. You're done!

                                             more

What kind of lettering is this?

These are pre-spaced letters, cut to perfection by computer technology. The letters press on to your wall or any other smooth surface.
                                             more

melanieb@paintedponylettering.com 481 E. Surrey Run Road Murray, UT 84107 Phone: (801) 262-7001

christine@paintedponylettering.com 639 Aspen Dr. Park City, UT 84098 Phone: (435) 649-7871